Numark PT01 Scratch等のアームを「カチッ」とロックするためのパーツです。
純正のクリップが割れてしまった方などにもオススメ。
3Dプリント出力物です。
PLA素材の場合は50-60度くらいの温度でも変形することがあります。高温の場所に保管、放置しないでください。
素材:PLA
積層ピッチ:0.06mm
ノズル径:0.4mm

It is a part for locking the arm such as Numark PT 01 SCCRATCH as "click".
It is also recommended for those who have broken genuine clips.
It is 3D printed output.
In the case of PLA material, it may deform even at temperatures around 50 - 60 degrees.
If you are planning to use it in places where you will be treble, please purchase the ABS material that you plan to add later.
Material: PLA
Lamination pitch: 0.06 mm
Nozzle diameter: 0.4 mm